Technicolor - Thomson SpeedTouchTM620 manual Backup System Software via FTP, Step Action, Ftpcd dl

Chapter 3

SpeedTouch™ System Software

3.2.1 Backup System Software via FTP

Introduction For backup reasons, you can transfer system software files from both

SpeedTouch™’s ‘/active’ and ‘/dl’ subdirectories to your local disk.

Backup procedure To transfer system software files from the SpeedTouch™ to your local disk as

backup, proceed as follows:

Step Action

1Open an FTP session to the SpeedTouch™. At the user name prompt, enter a user name and at the password prompt, if applicable, the Password (see “The Multi Level Access Policy Configuration Guide” for more information):

C:\>ftp <SpeedTouch™ IP address> Connected to <SpeedTouch™ IP address>.

220 Inactivity timer = 120 seconds. Use 'site idle <secs>' to change.

User (<SpeedTouch™ IP address>:(none)): JohnDoe

331 SpeedTouch (00-90-D0-01-02-03) User 'JohnDoe' OK. Password required.

Password:#####

230 OK ftp>

2Enter binary file transfer mode. Optionally you can enable hashing:

ftp> bin

200 TYPE is now 8-bit binary ftp> hash

Hash mark printing On ftp: (2048 bytes/hash mark). ftp>

3Change to the SpeedTouch™ subdirectory from which you want to get the system software file from. In the example below the ‘/dl’ subdirectory is chosen where the currently running - and usually most recent - system software file is stored:

ftp>cd dl

250 Changed to /dl ftp>

E-DOC-CTC-20051017-0155 v1.0 17