Technicolor - Thomson SpeedTouchTM620 manual Back up Configurations via FTP, For more information

Chapter 4

SpeedTouch™ Configuration Management

4.3.1 Back up Configurations via FTP

Introduction For backup reasons, you can transfer configuration files from both the

SpeedTouch™ ‘/active’ and ‘/dl’ subdirectories to your local disk.

Remind that a user.ini file in the system’s ‘/active’ subdirectory may contain an old saved configuration created before your latest software switch over.

Backup procedure To backup the current SpeedTouch™ configuration to your local disk as backup user.ini file, proceed as follows:

Step	Action
1	Open an FTP session to the SpeedTouch™. At the user name prompt,
	enter a user name and at the password prompt, the password (see
	“The SpeedTouch™ Multi Level Access Policy Configuration Guide”
	for more information):
	C:\>ftp <SpeedTouch™ IP address>
	Connected to <SpeedTouch™ IP address>.
	220 Inactivity timer = 120 seconds. Use 'site idle <secs>' to
	change.
	User (192.168.1.254:(none)): root
	331 SpeedTouch Password required.
	Password:
	230 OK
	ftp>
2	If required, save the current SpeedTouch™ configuration via the quote
	site saveall command:
3	ftp> quote site saveall
	200-
	200 CLI command "saveall" executed
4	Enter binary file transfer mode. Optionally you can enable hashing:
	ftp> bin
	200 TYPE is now 8-bit binary
	ftp> hash
	Hash mark printing On ftp: (2048 bytes/hash mark).
5	Change to the SpeedTouch™ ‘/dl’ subdirectory from which you want to
	get the latest configuration file from:
	ftp>cd dl
	250 Changed to /dl

E-DOC-CTC-20051017-0155 v1.0 33