Technicolor - Thomson SpeedTouchTM620 manual Syslog host on a remote network

Chapter 10

SpeedTouch™ Monitoring

Syslog host on a remote network

The default SYSLOG SpeedTouch™ service is configured to allow traffic from the SpeedTouch™ syslog daemon towards the WAN:

=>:service system list name=SYSLOG expand=enabled			Sta
Idx Name	Protocol	SrcPort DstPort Group
te

-----------------------------------------------------------------------

1 SYSLOG	udp	514	ena
bled	Description	System Logging Events
	Properties	client
	Managed parameters	state srcip
	Source Ip Selection	auto
	Interface Access List	any
=>	Ip Access List	any

Therefore, no additional configuration is needed in case you want to configure a syslog host on a remote network.

The example below shows the syslog rule to add for a syslog host with IP address

192.6.11.1.The local syslog host (192.168.1.10), configured before (See “ Syslog host on the local network”) will receive all generated syslog messages; the remote syslog host only receives syslog messages from all facilities with severity warning, error, critical, alert or emergency (all facilities, with severity warning and higher):

=>:syslog ruleadd fac=all sev=debug dest=192.6.11.1

=>:syslog list	192.6.11.1
1: all.debug
2: all.debug	192.168.1.10
=>

168 E-DOC-CTC-20051017-0155 v1.0