Technicolor - Thomson SpeedTouchTM620 manual How to Read Snmp Parameters via the CLI

Chapter 10

SpeedTouch™ Monitoring

10.2.8 How to Read SNMP Parameters via the CLI

About Reading SNMP The snmp get, snmp getNext and snmp walk commands allow you to Get, Parameters GetNext or Walk SNMP settings and/or counters from a MIB object. The MIB object

is identified by the MIB object’s ID. This is only used for ebugging purposes.

SNMP get Use the following CLI command to read a specific object ID:

{Administrator}[snmp]=>get [objectid = <string>]

With [objectID] the MIB ID of the object. This must include the instance which is 0 for scalar objects e.g. 1.3.6.1.2.1.1.1.0 or sysDescription.0

Example

To update the traffic load, use:

{Administrator}[snmp]=>1.3.6.1.2.1.10.94.1.1.7.1.12.601

VB_counter .1.3.6.1.2.1.10.94.1.1.7.1.12.601 84275 {Administrator}[snmp]=>1.3.6.1.2.1.10.94.1.1.7.1.12.601

VB_counter .1.3.6.1.2.1.10.94.1.1.7.1.12.601 84277 {Administrator}[snmp]=>1.3.6.1.2.1.10.94.1.1.7.1.12.601

VB_counter .1.3.6.1.2.1.10.94.1.1.7.1.12.601 84278 {Administrator}[snmp]=>1.3.6.1.2.1.10.94.1.1.7.1.12.601

VB_counter .1.3.6.1.2.1.10.94.1.1.7.1.12.601 84279

SNMP getnext Use the following CLI command to get the next available object ID:

{Administrator}[snmp]=>get [objectid = <string>]

With [objectid] the object identity to getNext from.

Example:

To get the iP address table, use:

{Administrator}[snmp]getnext objectid .1.3.6.1.2.1.4.20.1.1

VB_ipAdr .1.3.6.1.2.1.4.20.1.1.127.0.0.1 127.0.0.1 {Administrator}[snmp]getnext

VB_ipAdr .1.3.6.1.2.1.4.20.1.1.192.168.1.254 192.168.1.254 =>

The object ID is only required the first time. The second time a getnext is executed, the SpeedTouch™ will start looking from the previous object ID

E-DOC-CTC-20051017-0155 v1.0 149