Technicolor - Thomson SpeedTouchTM620 manual Resetting the SpeedTouch, =saveall, =system reboot

Chapter 13

Resetting the SpeedTouch™

13 Resetting the SpeedTouch™

Introduction If needed you can reset the SpeedTouch™ to factory defaults or just reboot.

Normal reboot To reboot the SpeedTouch™ without erasing the current configuration,use the following command:

=>:saveall

This command will save the current configuration to the user.ini file.

Now enter the following command:

=>:system reboot

This command will reboot the SpeedTouch™ and will load the user.ini file upon reboot so the previous saved configuration will be restored.

Reset to factory To reset the SpeedTouch™ to factory defaults, usethe following command: defaults

=>:system reset factory=yes proceed=yes

This command will delete the user.ini file (if the previous configuration was saved) and reboots the SpeedTouch™.

If there is an isp.def file present in the ‘dl directory it will load this file. The isp.def contains an Internet Service Provider specific configuration.

If no ips.def file is present on the device the SpeedTouch™ will reboot with the hardware defaults.

E-DOC-CTC-20051017-0155 v1.0 203