Technicolor - Thomson SpeedTouchTM620 manual Menu-driven CLI Navigation

Chapter 2

SpeedTouch™ Command Line Interface

2.5 Menu-driven CLI Navigation

Introduction To improve the user-friendliness of the SpeedTouch™ CLI, the CLI features a menu- driven interface.

Entering the CLI menu To enter the menu-driven interface, simply enter the command menu from the CLI prompt:

The semi-graphical CLI offers you an attractive and easy-to-use configuration environment for the CLI.

You can browse through the CLI command groups via the arrow keys. Pressing ENTER executes your selection, i.e. for entering a CLI command group. From each level you can select .. and press ENTER to go up one level.

Use TAB to change from the command menu to the control menu (the lower bar of the menu) and vice versa.

Executing commands To setup a CLI command, simply press ENTER on its name. You can configure and overview its various parameters at once. In case the parameter provides preset values, scroll through the available values via the UP and DOWN arrow keys. If you are satisfied with all parameter values, use TAB to select <OK> and press ENTER to execute the command:

Saving the configuration after configuring the SpeedTouch™ via the CLI, it is advised to save your configuration.

Save the complete SpeedTouch™ configuration to persistent memory by executing saveall after exiting the menu-driven CLI via <Cancel> from root menu.

E-DOC-CTC-20051017-0155 v1.0 13