Technicolor - Thomson SpeedTouchTM620 =service system modify name=HTTPs state=enabled port=448 =

Chapter 8

SpeedTouch™ Remote Access

Hyper-NAT Refinements The SpeedTouch™ features a powerful Hyper-NAT engine allowing the local hosts to share a single (remotely negotiated) public IP address.

In case Hyper-NAT is enabled on the WAN interface that will be used for remote management, and a static mapping has been made to allow remote hosts to address regular HTTPs services on a host residing on your local network, you must make sure that accessing the SpeedTouch™ Web Interface is still possible.

For more information on Hyper-NAT, see the SpeedTouch™ Hyper-NAT

Configuration Guide.

The default port for the HTTPs server is set to 443. This can be changed by executing the following command:

=>:service system modify name=HTTPs state=enabled port=448 =>

The command above will change the HTTPs server port of the SpeedTouch™ from port 443 (default) to port 448.

=>:service system list name=HTTPs expand=enabled

Idx NameProtocol SrcPort DstPort Group

-----------------------------------------------------------------------

1 HTTPs	tcp			448
Description		HTTP web server over ssl
Properties		server		aclip aclif aclifgroup map log
Attributes		state port
User Managed Attributes...		state port		aclip aclif aclifgroup map log
	Attribute Values :		enabled
	State
	Port		448
	Ip Access List		any
	Interface Access List	......	any	wan
	Interface Group Access List		lan
	Map List		448
	Logging		disabled

=>

!	NAT-refinements for SpeedTouch™ services should never be made in the
	NAT configuration menu, but always in System Services.

E-DOC-CTC-20051017-0155 v1.0 87