Technicolor - Thomson SpeedTouchTM620 manual How to Configure Cwmp Syntax

Chapter 8

SpeedTouch™ Remote Access

How to View the From the main prompt, use the following command to view the CWMP Parameters: Configuration

=>cwmp

=>[cwmp]config

This results in the following type of output on the screen, providing an overview of all parameters and their values:

State		: disabled
Mode		: full
Max Envelopes		: 2
Session Timeout		: 60
No Ip Timeout		: 10
Connection	Request Port	: 51005
Periodic Inform		: enabled
Periodic Inform Interval		: 3600 s
Connection	Request	: disabled
Connection	Request UserName	:
Connection	Request PassWord	:
Connection	Request Path	:
Connection	Request Authentication	: none
Qos class	range between 0 and	: 12
Boot delay		: 0 s

Similarly, to view the CWMP Server configuration, enter the following command sequence from the cwmp prompt:

=>[cwmp]server =>[cwmp server]config

How to Configure CWMP:

Syntax

From the cwmp prompt, use the following command to configure the CWMP parameters:

config

[state = <{disabledenabled}>] [mode = <{read-onlyfull}>] [periodicInform = <{disabledenabled}>]

[periodicInfInt = <number>] [sessionTimeout = <number>] [noIpTimeout = <number>] [maxEnvelopes = <number>] [connectionRequest = <{disabledenabled}>] [connectionReqPath = <string>] [connectionReqUserName = <string>] [connectionReqPsswd = <string>]

[connectionReqAuth = <{nonebasicdigest}>] [qos-class = <number>] [bootdelayrange = <number>]

E-DOC-CTC-20051017-0155 v1.0 109