Technicolor - Thomson SpeedTouchTM620 manual How to Configure, Parameter Descripion

Chapter 8

SpeedTouch™ Remote Access

How to Configure

CWMP:

Parameter Descripion

The CLI command uses the following parameters:

Parameter	Value	Description
state	enabled or	Enable or disable the CWMP
	disabled	daemon
mode	read-only or full	Set the operational mode of
		the CWMP daemon to read-
		only or full.
periodicInform	enabled or	Enable or disable CWMP
	disabled	periodic inform
periodicInfInt	number	Set the interval between two
		periodicInform messages in
		seconds
sessionTimeout	number	Set the HTTP session-timeout
		in seconds
noIpTimeout	number	Set the time (in seconds) the IP
		may be 0 after uploading a
		new config file
maxEnvelopes	number	Set the maximum number of
		SOAP envelopes sent within
		one http-message
connectionRequest	enabled or	Enable or disable CWMP
	disabled	connection request
connectionReqPath	text string	Set the path where the cwmp
		daemon can be reached
connectionReqUserName	text string	Set the username the ACS
		must use to log in
connectionReqPsswd	text string	Set the password the ACS
		must use to log in
connectionReqAuth	none, basic or	Set the authentication type of
	digest	modem CWMP server for
		asynchronous connects
qos-class	number	Set the quality of service class
		for outgoing CWMP data
bootdelayrange	number	Set the delay on boot before
		inform is sent

110 E-DOC-CTC-20051017-0155 v1.0