Technicolor - Thomson SpeedTouchTM620 manual Transfer system software to the SpeedTouch

Chapter 3

SpeedTouch™ System Software

Transfer system software to the SpeedTouch™

To transfer a system software file stored on your local disk to the SpeedTouch™,

proceed as follows:

Step	Action
1	Open an FTP session to the SpeedTouch™. At the user name prompt,
	enter a user name. At the password prompt, if applicable, enter the
	SpeedTouch™ system password (see “The SpeedTouch™ Multi Level
	Password Configuration Guide”):
	C:\>ftp <SpeedTouch™ IP address>
	Connected to <SpeedTouch™ IP address>.
	220 Inactivity timer = 120 seconds. Use 'site idle <secs>' to
	change.
	User (<SpeedTouch™ IP address>:(none)): JohnDoe
	331 SpeedTouch (00-90-D0-01-02-03) User 'JohnDoe' OK. Password
	required.
	Password:#####
	230 OK
2	Enter binary file transfer mode. Optionally you can enable hashing:
	ftp> bin
	200 TYPE is now 8-bit binary
	ftp> hash
	Hash mark printing On ftp: (2048 bytes/hash mark).
3	Change to the SpeedTouch™ ‘/dl’ subdirectory:
	ftp>cd dl
	250 Changed to /dl
4	Use the quote site software version command to check
	whether a passive system software version is stored in the ‘/dl’
	subdirectory :
	ftp> quote site software version
	200- Flash image	: 5.4.0.10.0
	200- Active SW	: ZZUIAA5.40A (5.4.0.a.0)
	200- Passive SW	: ZZUIAA5.40A (5.4.0.a.0)
	200-
	200 CLI command "software version" executed
5	In case a passive software version is found, use the quote site
	software deletepassive command to delete it:
	ftp> quote site software deletepassive
	200- Flash image	: 5.4.0.10.0
	200- Active SW	: ZZUIAA5.40A (5.4.0.a.0)
	200- Passive SW : ---
	200-
	200 CLI command "software deletepassive" executed

20 E-DOC-CTC-20051017-0155 v1.0