Chapter 5
Troubleshooting SpeedTouch™ IPSec
5 Troubleshooting SpeedTouch™ IPSec
Introduction IPSec is a complex protocol suite and therefore the SpeedTouch™ offers a number of troubleshooting methods.
Both the Web pages and the CLI interface allow you to check whether a tunnel setup was successful or has failed.
Via the CLI you can check the Syslog messages showing you the history of tunnel negotiation. Each Syslog message has a timestamp attached.
By contacting the SpeedTouch™ using the SNMP protocol, you can access the
IPSec MIB containing a lot of detailed tunnel information.
In this section The following topics are discussed in this section:
Topic | Page |
|
|
5.1 Via the Debug Web pages | 162 |
|
|
5.2 Via the CLI: Show command group | 165 |
|
|
5.3 Via the CLI: Debug command group | 167 |
|
|
5.4 Via SNMP | 170 |
|
|
161 | |
|
