Chapter 5
Troubleshooting SpeedTouch™ IPSec
5.3 Via the CLI: Debug command group
Traceconfig command The traceconfig command sets the level of debugging messages that are dumped to the screen. This is shown below:
[ipsec debug]=>traceconfig level | medium | |
none | low | |
high
[ipsec debug]=>traceconfig level medium [ipsec debug]=>
You can check the Phase 1 and 2 specific information being exchanged during tunnel setup via following command when you activate the tracing: Press <CRTL- Q>. In the tracing a lot of very detailed protocol information, exchanged during tunnel setup, is shown. Each tunnel negotiation/rekeying will echo these traces on the screen. You can stop the trace listing typing
167 | |
|
