Nortel Networks manual Removing the 8010co chassis bottom 312096-A bezel

Chapter 2 Installation 39

To connect cables to the chassis power supplies:

1Remove the 8010co chassis bottom bezels (if required).

a Using a Phillips screwdriver, loosen the 2 captive screws securing the bezel to the chassis (Figure 18).

b Pull the top of the bezel forward and then lift the 312096-A bezel from the two tabs on the bottom of the chassis.

c Repeat steps a and b for the second chassis, if installed.

Figure 18 Removing the 8010co chassis bottom 312096-A bezel

Bottom bezel

10422FA

Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis