|
| 11 |
Figures |
|
|
Figure 1 | Breaker interface panel | 19 |
Figure 2 | Front panel components | 20 |
Figure 3 | Shelf circuit breakers | 21 |
Figure 4 | Alarm module display panel | 22 |
Figure 5 | Back panel components | 24 |
Figure 6 | Shelf alarm connections (upper and lower shelves) | 25 |
Figure 7 | Configuring multiple BIPs to aggregate office alarms | 26 |
Figure 8 | Configuring standalone BIPs to report alarm status | 27 |
Figure 9 | Power terminal block | 28 |
Figure 10 | Power and grounding example | 29 |
Figure 11 | Opening the front panel | 30 |
Figure 12 | Accessing the alarm module | 31 |
Figure 13 | Default jumper settings | 31 |
Figure 14 | 8010co chassis configuration with BIP option | 32 |
Figure 15 | Contents of the BIP shipping container | 34 |
Figure 16 | Removing the plastic back cover from the BIP | 37 |
Figure 17 | Installing the BIP in the rack | 37 |
Figure 18 | Removing the 8010co chassis bottom | 39 |
Figure 19 | Location of power supplies | 40 |
Figure 20 | Loosening the power supply retaining screws | 41 |
Figure 21 | Disconnecting the power supply from the chassis backplane | 41 |
Figure 22 | Removing the plastic safety cover from the power supply | 42 |
Figure 23 | Power supply input and ground stud location | 42 |
Figure 24 | Power supply cables | 43 |
Figure 25 | Attaching the ground lead | 43 |
Figure 26 | Attaching the positive lead | 44 |
Figure 27 | Attaching the negative lead | 45 |
Figure 28 | Replacing the plastic safety cover on the power supply | 45 |
Figure 29 | Replacing the power supply | 46 |
Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis
