Chapter 2 Installation 51
6Attach one end of the BIP ground cable to the power terminal block (Figure 34).
a Loosen the power terminal block screw just enough to insert the ground cable lead (item 1 in Figure 34).
b Insert the lead and tighten the screw securely.
Figure 34 Attaching the BIP ground cable
1 |
|
| 2 |
|
|
|
|
|
|
| |
| +DC PS1 Upper |
|
|
| |
|
|
|
|
| |
3 2 1 3 2 1 |
| 3 2 1 3 2 1 A1 A2 B1 B2 | |||
PS (+) | PS (+) A/B Input Feed | PS | PS | – 48 VDC | |
Lower Shelf | Upper Shelf | Returns | Lower Shelf | Upper Shelf | A/B Input Feeds |
3 |
|
|
|
|
|
1 = Positive lead wire from power | 3 = Power terminal block label |
supply 1, upper shelf |
|
7Route the other end of the BIP ground cable to the rack grounding strip near the base of the rack (see Figure 31 on page 48).
Use a
8Go to the next section, “Connecting DC input power feeds to the BIP” on page 52.
Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis
