64Chapter 2 Installation
4Verify the following LEDs on the 8010co chassis:
—The (green) power supply LEDs for each power supply in both the upper and lower chassis are on.
(If any of the power supply LEDs are not on, replace the power supply.)
—The chassis fans are powering up.
If any of the previous steps indicate a problem with the installation, do the following:
1Set the switches for all power supplies in the upper and lower chassis to the off position (O = Off).
2Set the six circuit breakers on the BIP front panel to the off position (O = Off).
3Check that all cables are installed properly, and that all power supplies are firmly seated in their bays.
4Set the six circuit breakers on the BIP front panel to the on position ( = On).
5Set the switches for all power supplies in the upper and lower chassis to the on position ( = On).
6Proceed to “Verifying the LEDs” on page 63.
If the problem persists, go to Chapter 3, “Problem solving,” on page 67.
Powering off the system
To power off the system:
1Set the switches for all power supplies in the upper and lower chassis to the off position (O = Off).
You can access the power supply switches with the bezels installed.
2Set the six circuit breakers on the BIP front panel to the off position (O = Off).
3Turn off the input feed power at the DC power source.
Warning: Ensure the DC power source is off or disconnected. You may need to switch a circuit breaker off or turn off power at the DC input source. Be sure that the DC input source power is locked out and tagged.
