July 2006 | Installing the 201i server in the Succession 1000 system |
Installing the 201i server
Introduction
This section describes how to install the 201i server inside the Media Gateway or Media Gateway Expansion.
Before you begin
Determine which pair of consecutive slots are to contain the 201i server. The following table identifies the Media Gateway and Media Gateway Expansion slots into which the CallPilot 201i server can be installed:
| The 201i server |
|
Unit | can be installed in | Ineligible slots |
|
|
|
Media Gateway | Slots 1 and 2 | Slot 0 is dedicated to the SSC card. |
| Slots 2 and 3 | Slot 4 (includes slots 5 and 6) is |
|
| not used. |
|
|
|
Media Gateway | Slots 7 and 8 | Slot 10 is a |
Expansion | Slots 8 and 9 | second half of this slot does not |
| have a backplane connector. | |
| Slots 9 and 10 | |
|
| |
|
|
|
Note: The 201i server will not function properly when installed in slots 3 and 4.
For more information about card slots, refer to the Succession 1000 Planning and Installation Guide (NTP
For the logical slot numbers that you must use when you configure the Succession 1000 system, see “Card slots” on page 95.
201i Server Hardware Installation | 105 |
