Nortel Networks CalPilot 4.0 manual To set the CD-ROM drive DIP switches, What’s next?

July 2006 Preparing peripheral devices

To set the CD-ROM drive DIP switches

Set the CD-ROM drive DIP switches as described in the following table:

DIP switch	Description	Setting
1	Parity	ON
2	Termination	Note: For more information about daisy
		chaining SCSI devices, see “Setting SCSI
		device termination” on page 128.
		If the CD-ROM drive is the first and only
		device, set this switch to ON.
		If the CD-ROM drive is the first device
		and daisy chained with the tape drive, set
		this switch to OFF.
3	Test	OFF (for factory use only)
4	Block	OFF
5	Eject	OFF
		Note: If this switch is set to ON, the eject

button on the CD-ROM drive is disabled. To eject the CD-ROM from the drive, a software eject command must be sent over the SCSI bus.

What’s next?

If you are also installing a tape drive, set the tape drive SCSI ID (see page 126); otherwise, set the CD-ROM drive device termination (see page 128).

201i Server Hardware Installation 125