Nortel Networks CalPilot 4.0 manual Connecting the 201i server to the switch, ELAN, and Clan

July 2006 Connecting peripheral devices to the 201i server

Connecting the 201i server to the switch, ELAN, and CLAN

Introduction

The CLAN and ELAN connections are established by using the 201i server multi I/O cable.

ATTENTION
	For important considerations about using the Embedded
	LAN (ELAN) in your network, see “About the ELAN”
	in the CallPilot Installation and Configuration Task List.

To establish the switch and network connections

1 Do one of the following:
	IF you are installing the
	201i server in a	THEN
	large Meridian 1	ensure that the 50-pin amphenol connector
	(for example,	on the multi I/O cable (NTRH0912) is
	Option 51C)	connected to the newly installed backplane
		cable (NTRH3501) on the I/O panel at the
		rear of the switch.
	Option 11C	connect the 50-pin amphenol connector on
		the multi I/O cable (NTRH0912) to the
		high-density connector associated with the
		left slot occupied by the 201i server.

201i Server Hardware Installation 151