Installing the 201i server in a large Meridian 1 system | Standard 1.03 |
Required equipment
To move the secondary backplane connector, you need a Phillips No. 1 screwdriver. A pair of
To prepare the 201i server for installation in a Meridian 1 switch
1Remove the secondary backplane pin connector.
The pin connector has four pins. If necessary, use
2Remove the top and bottom screws that hold the secondary backplane connector in place on the stiffening cage.
3Loosen the middle screw, and then align the outside pair of screw holes on the bracket with the matching pair on the stiffening cage.
4Replace and alternately tighten all screws until the connector is evenly and securely fastened.
50 | CallPilot |
