Preparing peripheral devices | Standard 1.03 |
Setting the tape drive SCSI ID
Introduction
This section describes how to set the tape drive SCSI ID.
ATTENTION |
| |
You must power down the tape drive before changing the | ||
| ||
| SCSI ID. |
Note: The tape drive discussed in this section is the Tandberg SLR5 tape drive (NTRH9038). This is currently the only supported tape drive.
To set the tape drive SCSI ID
The SCSI ID setting is located on the back of the tape drive. See the diagram on page 127.
Note: The appearance and size of the tape drive cabinet is subject to change. The diagram is an example of the key components.
126 | CallPilot |
