Nortel Networks CalPilot 4.0 manual Multi I/O cable description, Network requirements

About the 201i server Standard 1.03

Network requirements

Appropriate networking equipment must be available for both the CLAN and ELAN.

The CLAN and ELAN must be properly configured for correct CallPilot operation. To ensure correct configuration, Nortel recommends that you consult a network specialist.

ATTENTION
	For important considerations about using the ELAN in
	your network, see “About the ELAN” in the CallPilot
	Installation and Configuration Task List.

Multi I/O cable description

The multi I/O cable contains four connectors, and is approximately 3 m

(10 ft) in length. See the following diagram:

Multi I/O cable NTRH0912

Drain wire

50-pin

amphenol connector

ELAN connector

CLAN connector

RS-232 connector

RJ-45 female-to-female gender change jack

Note: If you need more than 3 m (10 ft) of multi I/O cable, use the supplied RJ-45 female-to-female gender change jacks to attach additional cable. A maximum of 76.2 m (250 ft) is supported.

G101441

26 CallPilot