Copyright © Nortel Networks Limited 2006 | 59 |
You will see the following message:
Obtaining IP Addresses for SysMgr/AcctMgr
Failover Operation
Note: If you don't have plan to configure the failover service, type in the same primary service logical IP address and primary machine logical IP address or type 0.0.0.0 instead.
17Enter the <Machine Logical IP Address of the other MgmtSvr> (in
Example: 120.120.13.22
18Enter the <service logical IP address of the SysMgr> (in
Example: 120.120.13.22
19Enter the <service logical IP of the AcctMgr> (in
Example: 120.120.13.22
”You have entered the following IP addresses: Machine Logical IP Address of the other MgmtSvr: 120.120.13.22
Service Logical IP Address of SysMgr: 120.120.13.22
Service Logical IP Address of AcctMgr: 120.120.13.22
20Is this information correct? (y/n)
If the information is correct, press Y and Enter.
21You are now configuring the Syslog daemon. Press Enter to continue.
22Is this the Primary Accounting Server Machine in a DUPLEX configuration [Y/N]?
Select N and Enter.
23Press Enter to configure the LOM port.
You will need to enter the following information:
•IP address for the Physical Ethernet Net Management port
•Netmask for the Physical Ethernet New Management port
•Gateway IP address
Note: If the Net Management port was previously configured, the IP address, Netmask address, and Gateway address are shown as the defaults for the entries in steps 24, 25, and 26 below. Press Enter to accept the default IP addresses.
MCS