Copyright © Nortel Networks Limited 2006 | 63 |
Is this IPMP group configuration acceptable? (Y/N)
Select Y to accept or N to change.
14The default route IP address should appear. If correct, press Enter. Otherwise, type it in, then press Enter.
Note: If your configuration does not include a router, then enter the machine logical IP address of your server.
15Do you intend to deploy the Web Server to this machine (y,n)? Enter Y.
16You are now configuring the Syslog Daemon. Press Enter to continue.
17Does the Management Server have a SysMgr Service Logical IP Address [Y/N]? Select N.
18Press Enter to configure the LOM port.
You will need to enter the following information:
•IP address for the Physical Ethernet Net Management port
•Netmask for the Physical Ethernet New Management port
•Gateway IP address
Note: If the Net Management port was previously configured, the IP address, Netmask address, and Gateway address are shown as the defaults for the entries in steps 19, 20, and 21 below. Press Enter to accept the default IP addresses.
19Enter the <IP address for the Physical Ethernet Net Management Port> (Default: 0.0.0.0)
20Enter the <netmask for the Physical Ethernet Net Management Port> (Default: 255.255.255.0)
21Enter the <Gateway IP address> (Default: 0.0.0.0)
You are asked to confirm the LOM port configuration.
22Type Y to accept the LOM port configuration or N if you want to change something.
The system will now reboot and come up requesting that you insert CD5.
ATTENTION
If you are not prompted for CD5, contact support.
MCS
