Onkyo HT-RC180 Advanced Setup—Continued, Remote ID, 1, 2, Changing the Remote Controller’s ID

Advanced Setup—Continued

Remote ID

Remote ID 1, 2, 3

When several Onkyo components are used in the same room, their remote ID codes may overlap. To differen- tiate the AV receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3.

Changing the Remote Controller’s ID

1	While holding down the [RECEIVER] button, press and hold down the [SETUP] button
	until the [RECEIVER] button lights up (about 3 seconds).
2	Use the number buttons to enter ID 1, 2, or 3.
	The [RECEIVER] button flashes twice.

Note:

If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID, otherwise, you won’t be able to control it with the remote controller.

Multi Zone

See “Setting the Multi Zone” on page 119.

Tuner

FM/AM Frequency Step (North American and Taiwan models)

AM Frequency Step (European, Australian and Asian models)

See “FM/AM Frequency Step Setup” on page 52.

SAT Radio Mode (TX-NR807: North American models)

If you connect a SIRIUS Satellite Radio antenna to the AV receiver (sold separately), set this setting to “SIR- IUS”. See the separate Satellite Radio Guide for more information.

Antenna Aiming (TX-NR807: North American models)

The ID of the Sirius Connect Home Tuner is displayed here. You must sign up to obtain a SIRIUS ID. See the separate Satellite Radio Guide for more information.

SIRIUS Parental Lock (TX-NR807: North American models)

This item is for use with SIRIUS Satellite Radio. It’s not available if “SAT Radio Mode” is set to “None”. See the separate Satellite Radio Guide for more information.

HDMI

Audio TV Out	Off: HDMI audio is not output to TV (default).
	On: HDMI audio is output to TV and the sound will be heard from the TV
	speakers.

This preference determines whether audio received at the HDMI IN is output by the HDMI OUT. You may want to turn this preference on if your TV is connected to the HDMI OUT and you want to listen to the audio from a component that’s connected to an HDMI IN, through your TV’s speakers. Normally, this should be set to “Off”.

100