Onkyo TX-NR807 Press Enter, Room correction and speaker setup starts, Following screen appears

First Time Setup—Continued

4

5

• Make the room as quiet as possible.	6
Background noise can disrupt the
room measurements. Close
windows, silence cell phones,	7
televisions, radios, air conditioners,

fluorescent lights, home appliances, light dimmers, or other devices.

•Cell phones should be turned off or placed away from all audio electronics during the measurement process as Radio Frequency Interference (RFI) may cause measurement disruptions (even if the cell phone is not in use).

Press [ENTER].

The room correction and speaker setup starts.

MultEQ: Auto Setup

Do not unplug setup microphone.

Please keep quiet.

Now measuring. . .

Test tones are played through each speaker as Audyssey MultEQ® Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during

measurements and do not stand8 between speakers and the microphone.

The following screen appears.

MultEQ: Auto Setup

Please place setup microphone at 2nd position at

ear height.

Next

Place the setup microphone at the next position (page 54), and then press [ENTER].

Audyssey MultEQ performs more measurements. This takes a few minutes.

MultEQ: Auto Setup

Do not unplug setup microphone.

Please keep quiet.

Now measuring. . .

When prompted, place the setup microphone at the next position, and repeat step 5.

After the 3rd to the 5th measure- ment, the following screen appears.

MultEQ: Auto Setup

Please select [Next], when measuring next position,

and select [Finish], when ending.

Next

Finish(Calculate)

Use the Up and Down [q]/[w] but- tons to select an option, and then press [ENTER].

Next:

Select “Next” to begin measuring the next measurement position. After the 6th measurement has been taken, the procedure automatically proceeds to step 8.

Finish(Calculate):

Select this if you don’t want to measure any more listening posi- tions and are ready to calculate the results, then go to step 8.

When the measurements are complete, the following screen

appears.

MultEQ: Auto Setup

Calculating...

56