Onkyo TX-NR807 Changing the Input Display, First Time Setup—Continued, The “Tuner” menu appears

First Time Setup—Continued

3	Use the Up and Down [q]/[w] but-
	tons to select “3. Tuner”, and
	then press [ENTER].
	The “Tuner” menu appears.
	(North American and Taiwan models)
	7–3. Tuner
	FM/AM Frequency Step	200kHz/10kHz
	SAT Radio Mode	None
	(TX-NR807)
	(European, Australian and Asian
	models)
	7–3. Tuner
	AM Frequency Step	9kHz
4	Use the Left and Right [e]/[r]
	buttons to select:
	(North American and Taiwan models)
	200kHz/10kHz:
	Select if 200 kHz/10 kHz steps are
	used in your area.
	50kHz/9kHz:
	Select if 50 kHz/9 kHz steps are
	used in your area.
	(European, Australian and Asian

GAME TV/TAPE

VCR/DVR

1	Press the [TV/TAPE], [GAME] or
	[VCR/DVR] input selector button
	so that “TV/TAPE”, “GAME” or
	“VCR/DVR” appears on the dis-
	play.
	or

or

	models)
	10kHz: Select if 10 kHz steps are
	used in your area.
	9kHz: Select if 9 kHz steps are used
	in your area.
5	Press the [SETUP] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Changing the Input Display

2

or

or

(3 seconds)

Press and hold down the [TV/ TAPE], [GAME] or [VCR/DVR] input selector button (about 3 seconds) to change the setting.

Repeat this step to select MD, CDR, or DOCK.

For the TV/TAPE input selector, the setting changes in this order:

TV/TAPE → MD → CDR

→	DOCK
	→

For the GAME input selector, the setting changes in this order:

GAME ↔ DOCK

For the VCR/DVR input selector, the setting changes in this order:

VCR/DVR ↔ DOCK

If you connect an u-capable Onkyo MiniDisc recorder, CD recorder, or RI Dock to the TV/TAPE IN/ OUT jacks, or connect an RI Dock to the GAME IN or VCR/DVR IN jacks, for uto work properly, you must change this setting.

This setting can only be changed on the AV receiver.

Notes:

•DOCK can be selected for the TV/TAPE or GAME or VCR/DVR input selector, but not at the same time.

•Enter the appropriate remote control code before using the AV receiver’s remote controller for the first time (see page 125).

53