Onkyo 29400021 Using the Remote Controller in Zone, 2/3 and Multiroom Control Kits TX-NR807

Models: TX-NR807 HT-RC180 29400021

1 148
Download 148 pages 17.31 Kb
Page 122
Image 122
Using the Remote Controller in Zone

Multi Zone—Continued

Using the Remote Controller in Zone

2/3 and Multiroom Control Kits

(TX-NR807)

Using a Multiroom Kit with a Cabinet

In this setup, the IR receiver picks up the infrared signals from the remote controller and feeds them to the AV receiver located in the cabinet via the connecting block.

To control the AV receiver with the remote controller while you’re in Zone 2 or Zone 3, you’ll need a commer- cially available multiroom remote control kit for each zone.

Multiroom kits are made by Niles and Xantech. These kits can also be used when there isn’t a clear line of sight to the AV receiver’s remote sensor, such as when it’s installed inside a cabinet.

Using a Multiroom Kit with Zone 2/3

In this setup, the IR receiver in Zone 2/3 picks up the

IR IN

Inside

cabinet

2/3 and Multiroom Control KitsUsing a Multiroom Kit with a Cabinet IR receiver Connecting

block

Remote controller

infrared signals from the remote controller and feeds them through to the AV receiver in the main room via the connecting block.

Signal flow

Using a Multiroom Kit with Other Components

IR IN

Connecting block

Main room

Signal flow

IR receiver

Remote controller

Zone 2/3

In this setup, an IR emitter is connected to the AV receiver’s IR OUT jack and placed in front of the other component’s remote control sensor. Infrared signals received at the AV receiver’s IR IN jack are fed through to the other component via the IR emitter. Signals picked up by the AV receiver’s remote control sensor are not output.

Using a Multiroom Kit with Zone 2/3Using a Multiroom Kit with Other Components IR receiver Connecting

block

The miniplug cable from the connecting block should be connected to the AV receiver’s IR IN jack, as shown below.

From the connecting block

Miniplug cable

IR IN

IR OUT Manual background

Manual background AV receiver

IR Emitter

Remote controller

Other component

AV receiver

Signal flow

The IR emitter should be connected to the AV receiver’s IR OUT jack, as shown below.

Miniplug cable

Other component

Remote control sensor

Manual backgroundManual background Emitter

Miniplug

IR Emitter

AV receiver

Manual background Signal flow

122

Page 122
Image 122
Onkyo Using the Remote Controller in Zone, 2/3 and Multiroom Control Kits TX-NR807, Using a Multiroom Kit with Zone 2/3