Onkyo 29400021 Error Messages, Disconnect the speaker setup microphone, Ambient noise is too high

First Time Setup—Continued

9

10

11

When the calculations are com- plete, the following screen

appears.
MultEQ: Auto Setup
-- Review SP Configuration --
Subwoofer	No
Front	Full Band
Center	40Hz
Surround	120Hz
Front Wide	Full Band
Front High	Full Band
Surr Back	150Hz
Surr Back Ch	2ch
Save
Cancel

Use the Up and Down [q]/[w] but- tons to select an option, and then press [ENTER].

The options are:

Save:

Save the calculated settings and exit the room correction and speaker setup.

Cancel:

Cancel the room correction and speaker setup.

Note:

You can view the calculated settings for the speaker configuration, speaker dis- tances, and speaker levels by using the Left and Right [e]/[r] buttons.

If you selected “Save”, the results are saved, and the following screen appears.

MultEQ: Auto Setup

Saving...

Disconnect the speaker setup microphone.

MultEQ: Auto Setup

Please, unplug setup microphone.

Notes:

•When the room correction and speaker setup is complete, the “Equalizer Settings” (page 87) will be set to “Audyssey” and the “Dynamic EQ” (page 91) will be set to “On”.

•You can cancel the Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone.

Error Messages

While the room correction and speaker setup is in progress, one of the following error messages may appear:

❏Ambient noise is too high.

MultEQ: Auto Setup

Ambient noise is too high.

Retry

Cancel

This message appears if the background noise is too loud and the measurements cannot be performed properly.

Remove the source of the noise and try again.

Retry: Return to the measured point immediately before and start set up again.

Cancel: Cancel the room correction and speaker setup.

❏Speaker Detect Error

This message appears if a speaker is not detected. “Yes” means that a speaker was detected. “No” means that no speaker was detected.

MultEQ: Auto Setup

Speaker Detect Error

FL	:	No	FR	:	---
SL	:	---	SR	:	---
FWL :		---	FWR :		---
FHL	:	---	FHR	:	---
SBL	:	---	SBR	:	---
C	:	---	SW	:	---

Retry

Cancel

The front speaker has not been detected.

MultEQ: Auto Setup

Speaker Detect Error

FL	:	Yes	FR	:	No
SL	:	---	SR	:	---
FWL :		Yes	FWR :		Yes
FHL	:	Yes	FHR	:	Yes
SBL	:	---	SBR	:	---
C	:	Yes	SW	:	---

Retry

Cancel

One of the front speakers has not been detected.

57