Onkyo HT-RC180 5 6 7, Controlling Other Components—Continued, If the brand name is not found

Controlling Other Components—Continued

5

6

7

Use the Up and Down [q]/[w] but- tons to select category, and then press [ENTER].

The brand name input panel appears.

8–1.	Remote Mode Setup		TV
Category			TV
Brand
A B C D E F G H		I	J K L M
N O P Q R S T U V W X Y Z
1 2	3 4 5 6 7 8	9	0 – & @
	Space	Back Space	Search

Use the arrow [q]/[w]/[e]/[r] but- tons to select a character, and then press [ENTER].

Repeat this step from the 1st character to the 3rd character of the brand name. When you have entered the 3rd charac- ter, select “Search” and press [ENTER].

After searching, a list of the brand name appears.

8–1. Remote Mode Setup	TV
Category	TV
Brand	SON
Sonawa
Sonber
Songba
Sonic
Soniko
	Not Listed

If the brand name is not found:

Use the Right [r] button to select “Not Listed”, and then press [ENTER].

The brand name input panel appears.

Use the Up and Down [q]/[w] but- tons to select brand, and then press [ENTER].

After searching is completed, a mes- sage for remote control code transfer will appear.

8–1. Remote Mode Setup	TV
Category	TV
Brand	XXXXX

Now we are ready to transfer data to Remote

Please hold remote so that it is facing the receiver.

Use ENTER button of your remote to activate “OK”.

Ready?

OK

To use the remote controller, point it at the AV receiver’s remote control sen- sor, as shown below.

Transmitter

AV receiver

Incoming sensor

15

15

Approx. 15° off center

(Left/Right/Up/Down) 16ft. (5 m)

On the remote controller press the [ENTER] button.

8–1. Remote Mode Setup	TV
Category	TV
Brand	XXXXX

Wait

When the transfer is successful, the fol- lowing screen appears. Try it.

8–1. Remote Mode Setup	TV
Category	TV
Brand	XXXXX

1. Push remote Mode [TV].

2.Push some key to see if the TV responds.

3.Push remote Mode [RECEIVER].

4.Choose “Works” or “Doesn’t work”.

Works

Doesn’t work (try next Code)

*When category other than TV have been selected, the content is different.

8	If you can control component,
	press the [RECEIVER] button,
	use the Up and Down [q]/[w] but-
	tons to select “Works”, and then
	press [ENTER].
	The “Remote Mode Setup” menu
	appears.

If you cannot control component, use the Up and Down [q]/[w] but- tons to select “Doesn’t work (try next Code)” and press [ENTER].

The next code is appear.

9	When you’ve finished, press the
	[SETUP] button.
	The setup menu closes.

124