Onkyo HT-RC180, 29400021, TX-NR807 instruction manual 103, Lock Setup, Digital Input Signal Formats

Advanced Setup—Continued

Lock Setup

With this preference, you can protect your settings by locking the setup menus.

1 Press the [RECEIVER] button followed by the [SETUP] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2 Use the Up and Down [q]/[w] buttons to select “9. Lock Setup”, and then press [ENTER].

The “Lock Setup” menu appears.

9.	Lock Setup
Lock	Unlocked

3 Use the Left and Right [e]/[r] buttons to select:

When the setup menus are locked, you cannot change any setting.

Locked:

Setup menus locked.

Unlocked:

Setup menus not locked.

4 Press the [SETUP] button. The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Digital Input Signal Formats

The digital input signal formats are available only for the input sources that you have assigned a digital input jack (see page 50).

Normally, the AV receiver detects the signal format auto- matically. However, if you experience either of the fol- lowing issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS:

•If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM.

•If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS.

•The setting is stored individually for each input selec- tor.

1Press the [RECEIVER] button, and then press and hold [AUDIO] button for about 8 seconds.

2While “Auto” is displayed (about 3 sec- onds), press the Left and Right [e]/[r] buttons to select: PCM, DTS or Auto.

PCM:

Only 2-channel PCM format input signals will be heard. If the input signal is not PCM, the PCM indicator will flash and noise may also be pro- duced.

DTS:

Only DTS (but not DTS-HD) format input sig- nals will be heard. If the input signal is not DTS, the DTS indicator will flash and there will be no sound.

Auto (default):

The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead.

103