Onkyo HT-RC180 Basic Operations, Adjusting the Bass & Treble, Displaying Source Information

Basic Operations—Continued

TONE, e, r DIMMER DISPLAY

DISPLAY

Press

[RECEIVER] MUTING

first.

SP LAYOUT

DIMMER SLEEP

Adjusting the Bass & Treble

You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode is selected.

1		Press the [TONE] button repeat-
	AV receiver	edly to select either “Bass” or
		“Treble”.

Note:

To bypass the bass and treble tone circuits, select the Direct, Pure Audio or THX listening mode.

Displaying Source Information

You can display various information about the current input source as follows.

Remote	Press the [RECEIVER] button,
controller	and then press the [DISPLAY]
	button repeatedly to cycle
	through the available informa-
	tion.

Note:

This procedure can also be performed on the AV receiver by using its [DISPLAY] button.

The following information can typically be displayed for input sources.

Input source Listening

mode

Signal format* Sampling

frequency

Input Signal

Resolution

Output

Resolution

2

AV receiver

Use the Up [r] and Down [e] buttons to adjust.

Tip:

This procedure can also be performed on the remote controller by using [AUDIO] button (see page 104).

*If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format and the number of channels is displayed. For some digital input sig- nals, including multichannel PCM, the signal format, number of channels, and sampling frequency is displayed.

Information is displayed for about three seconds, then the previ- ously displayed information reappears.

■Bass

You can boost or cut low-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

■Treble

You can boost or cut high-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

61