Onkyo 29400021, HT-RC180 Speaker Settings, Powered Zone 2/3, First Time Setup—Continued, Notes

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run Audyssey MultEQ® Room Correction and Speaker Setup again (see page 54).

If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms.

If you’ve connected your front speakers to the FRONT L/R and SURR BACK/ZONE 2 L/R terminal posts for bi-amping, you must change the “Speakers Type(Front)” setting. For hookup information, see “Bi-amping the Front Speakers” on page 21.

Notes:

•When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room.

•Before you change these settings, turn down the volume.

1Press the [RECEIVER] button, followed by the [SETUP] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2 Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [ENTER]. The “Speaker Setup” menu appears.

2. Speaker Setup

1. Speaker Settings

2.Speaker Configuration

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

3	Use the Up and Down [q]/[w] but-
	tons to select “1. Speaker Set-
	tings”, and then press [ENTER].
	The “Speaker Settings” menu appears.
	2–1. Speaker Settings
	Speaker Impedance	6ohms
	Speakers Type(Front)	Normal
	Powered Zone2	Not Act
	Powered Zone3	Not Act

4	Use the Up and Down [q]/[w] but-
	tons to select “Speaker Imped-

ance”, and then use the Left and Right [e]/[r] buttons to select:

4ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6.

6ohms: Select if the impedances of all speakers are between 6 and 16 ohms.

5	Use the Up and Down [q]/[w] but-
	tons to select “Speakers

Type(Front)”, and then use the Left and Right [e]/[r] buttons to select:

Normal: Select this if you’ve con- nected your front speakers normally.

Bi-Amp:Select this if you’ve con-

	nected your front speakers
	for bi-amped operation.
	Note:
	Powered Zone2/3 cannot be used if
	“Speakers Type(Front)” is set to
	“Bi-Amp”.
6	Press the [SETUP] button.
	The setup menu closes.

Powered Zone 2/3

See “Setting the Powered Zone 2/3” on page 118.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

51