Manipulating ChapterClips 6

Thumbnails

RUN DOWN CARD:

The maximum number of overwrites on the P2 card has been exceeded.

DIR ENTRY NG CARD:

The directory structure on the P2 card is not supported.

•For details on P2 card status indications, refer to [2. L/R P2 card status (remaining free space)].

•If the number of recorded clips reaches the limit (1000) on the P2 card status indicator, “OVER MAX NUMBER CLIPS” is displayed in the WARNING field.

When “USED” is selected:

1 2

3 5

4

1Write-protect mark

The mark appears if the P2 card is write-protected.

2L/R P2 card status (used memory capacity)

The used memory capacity of the P2 card is indicated by a bar graph and a percentage figure. The bar graph indicator moves to the right as the used memory capacity increases.

The following indications may appear, depending on the card status:

FORMAT ERROR!:

An unformatted P2 card is inserted.

NOT SUPPORTED!:

An unsupported card is inserted in the camera.

NO CARD!:

P2 cards are not inserted.

Use the cursor button to place the cursor on the P2 card for data you want to access and press the SET button to display detailed information about the P2 card to check individual information such as the serial number and the user ID.

3L/R P2 card used memory capacity/total capacity Displays the used memory capacity on a P2 card and the total capacity in minutes. The digits representing less than minutes are rounded down. The used memory capacity of a write-protected P2 card is displayed as 100 %.

Note that the indicated capacity will vary according to the frame rate in native recording with VFR operation.

4Used 3D/2D LL recording capacity

Displays the used memory capacity for recording, calculated from the used memory capacity of the P2 cards inserted into card slots L and R.

5Warning symbol

Inserting the following type of P2 cards will display the (  ) symbol.

RUN DOWN CARD:

The maximum number of overwrites on the P2 card has been exceeded.

DIR ENTRY NG CARD:

The directory structure on the P2 card is not supported.

•For details on P2 card status indications, refer to [2. L/R P2 card status (used memory capacity)]

•If the number of recorded clips reaches the limit (1000) on the P2 card status indicator, “OVER MAX NUMBER CLIPS” is displayed in the WARNING field.

SD memory card Status Display

The status display enables a confirmation of the SD memory card formatted condition, available memory capacity etc. From the thumbnail menu, select PROPERTY

DEVICES SD CARD.

If the format is compatible with SD standards, the message

SD STANDARD : SUPPORTED

If the format is not compatible with SD standards, the message

SD STANDARD : NOT SUPPORTED

is displayed. If this is the case, writing or reading will not be successful. Format the card with the unit. For more information on formatting SD memory cards, see [Formatting SD Memory Cards] (page 100).

104