Chapter 5  Preparation

Power Supply

A battery or an external DC power supply can be used as

2 Insert the battery and slide it in the direction of

the power supply for the camera-recorder.

 

the arrow.

Using a Battery

Release lever

 

Preparation 5 Chapter

The following is a list of batteries that have been tested and verified to work with the camera.

Anton/Bauer batteries HYTRON140 DIONIC90, DIONIC160 IDX batteries “ENDURA” E-10 / E-10S PAG batteries PAGL95

NOTE

•Although other batteries may be used by changing the menu setting, it is recommended that you use batteries that have been tested and verified to work with camera.

•Charge the battery with the battery charger before using it. (Please refer to the battery charger’s instruction manual for information about charging.)

Mounting the Battery and Settingthe Battery Type

NOTE

Removing the battery

Completely push down and hold the release lever on the battery holder.  Then, slide the battery in the opposite direction to the arrow while holding the lever down.

Using an Anton/Bauer Battery

1

Mount an Anton/Bauer battery.

3 Set the battery type.

• Select the battery type listed under BATTERY SELECT. Select the menu option BATTERY SELECT from the setting menu BATTERY SETUP screen.

NOTE

Anton/Bauer Battery

NOTE

The Anton/Bauer battery holder includes both a power supply output connector for lighting and a lighting control switch, which are convenient when attaching a light. Please contact Anton/Bauer for information about the lighting system.

If you wish to turn on a light using the Camera Studio System (AG-BS300, AG-CA300G), attach the battery plate to the AG-CA300G and mount the battery on it for the supply power for the light via the battery plate. If power is supplied via the Light connector of this unit, the unit may not operate, because of overcurrent protection of AG-BS300/AG-CA300G activated by excess current generated when the light is turned on.

84