Panasonic AJ-D250P Repeat playback, Setting the Begin and END points Menu mode

Operation

Repeat playback

Setting the BEGIN and END points [Menu mode]

1

2

Set the unit to the menu mode (by setting the LOCAL/MENU/REMOTE switch to the MENU position).

Select the “BGN PRESET” or “END PRESET” setup menu item, and press the DATA+ button (PAUSE/STILL button) or DATA– button (PLAY button).

(See page 29)

<Note>

It is possible to select whether the BEGIN or END point is to be set or not by operating the DATA+ or DATA– button.

3

4

5

6

7

Select TC or CTL using the COUNTER button. <Note>

If the RESET button is pressed while the unit is in CTL mode, 00:00:00:00 will be set.

Select the digit to be changed (blinking display) using the UP button (FF button) or DOWN button (STOP button).

The frame digits cannot be selected. They always appear as “00.”

The value is incremented or decremented using the DATA+ button (PAUSE/STILL button) or DATA– button (PLAY button).

Press the SET button (REC button) upon completion of the settings.

The settings are now stored in the memory.

Set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position.

<Notes>

O“– –:– –:– –:– –” appears on the display when the points have not been set. In this case, repeat playback will start at the beginning of the tape which serves as the BEGIN point and end at the end of the tape which serves as the END point.

OWhen the MODE button (REW button) is pressed instead of the SET button upon completion of the settings, the time code setting will be canceled.

16