Panasonic AJ-D250P operating instructions Stx Osr Etx, Stx Osu Etx

RS-232C

$Operation control commands

	Sends data of computer		Return data from VTR		Description of command
	[STX] OSR:n [ETX]		[STX] OSR [ETX]	Sets the tape playback speed in the reverse direction.
Parameters
OIn the case of a DVCPRO
	format tape
	n = 0: STILL	6: a1.85
	1: a0.03	7: a4.1
	2: a0.1	8: a9.5
	3: a0.3	9: a16.0
	4: a0.43	A: a32.0
	5: a1
OIn the case of a DV format tape
	n = 0: STILL	6: a1.85
	1: a0.03	7: a3.1
	2: a0.1	8: a9.5
	3: a0.3	9: a16.0
	4: a0.5	A: a32.0
	5: a1
	[STX] OSU [ETX]		[STX] OSU [ETX]	Controls the tape playback speed.
				Set the VTR to the STILL PAUSE mode using the OSL
				command, and send the OSU command. Each time the
				OSU command is sent, the playback speed shifts by one
				setting in the direction of the arrows below.
				If the highest playback speed is already set, the speed does
				not shift any further, and error code ER001 is returned from
				the VTR.
					In the case of a DVCPRO format tape
					–32.0 .–16.0 .–9.5 .–4.1 .–1.85 .–1 .–0.43 .–0.3 .
					–0.1 –0.03 .STILL . +0.03 . +0.1 . +0.3 . +0.43 . +1 .
					+1.85 . +4.1 . +9.5 . +16.0 . +32.0
					In the case of a DV format tape
					–32.0 .–16.0 .–9.5 .–3.1 .–1.85 .–1 .–0.5 .–0.3 .
					–0.1 –0.03 .STILL . +0.03 . +0.1 . +0.3 . +0.5 . +1 .
					+1.85 . +3.1 . +9.5 . +16.0 . +32.0
	[STX] OTE:m [ETX]		[STX] OTE [ETX]	Selects whether to set E-E output or V-V output when the
Parameters				VTR is in the STOP mode, FF mode or REW mode.
m = E:
	E-E (Electric modulation to
	Electric play back)
m = T:
	V-V (VTR to VTR recording)

<Note>

Refer to the RS-232 mode transition table (on pages 71, 72) for the conditions under which the operation control commands are accepted.

54