First Edit Function (Preparing the editing tape)

The CTL (control) signal must be recorded ahead of time onto the editing tape. The method used to record it differs depending on whether assemble editing or insert editing is to be performed.

First edit for assemble editing

In the case of a tape for assemble editing, the CTL signal is recorded at the beginning of where the recording is to be commenced.

Position where CTL signal recording starts

3 sec.

Direction of tape travel

CTL signal recording

–23 sec. position

0 sec. position

First edit for insert editing

In the case of a tape for insert editing, the CTL signal is recorded from the beginning of where the recording is to be commenced to the end.

The “E-00” servo lock error appears on the tape counter when insert editing is performed for a tape on which the CTL signal has not been recorded.

When insert editing is performed, the CTL signal must be recorded ahead of time.

<Note>

When first edit is to be performed, operation can be conducted by connecting the RS-232C remote control (AJ-A250), which is available as an optional accessory. However, control using the RS-232C interface (EFE command) can also be exercised from a computer.

(See page 50)

37

Page 37
Image 37
Panasonic AJ-D250P operating instructions First Edit Function Preparing the editing tape, First edit for assemble editing