Panasonic AJ-D250P Setting the Begin and END points Front panel, Setting the repeat playback mode

Operation

Setting the BEGIN and END points [Front panel]

1

2

Set the unit to the local mode (by setting the LOCAL/MENU/REMOTE switch to the LOCAL position).

When the BEGIN or END button on the front panel is pressed, the current position is set as the BEGIN or END point.

Displaying the BEGIN and END points

1

2

Set the unit to the remote mode (by setting the LOCAL/MENU/REMOTE switch to the REMOTE position).

When the BEGIN or END button on the front panel is pressed, the BEGIN or END point is displayed while the button is held down.

The settings are not changed.

Setting the repeat playback mode

1

2

3

Set the unit to the menu mode (by setting the LOCAL/MENU/REMOTE switch to the MENU position).

Select the “MEMORY MODE” setup menu item, and select the repeat playback mode. (See page 29)

Setting	Operation
OFF	Normal operation
M-STOP	The tape stops near the BEGIN point when it is fast-forwarded
	or rewound.
REPT1	When the tape playback reaches the END point, the tape is
	rewound to the BEGIN point, where it stops.
CONT	When the tape playback reaches the END point, the tape is
	rewound to the BEGIN point and playback is repeated.

Set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position.

<Notes>

OThe picture quality will deteriorate when the same tape is repeatedly played back over and over again. As a general guideline, replace the tape with a new one after about 100 repeat playback operations.

OWhen repeat playback is to be initiated using a consumer-use tape, the unit will not operate even if CONT has been selected as the setup menu item No.111 “MEMORY MODE” setting. (See page 29)

17