8. Programmable Features

3.Scroll to “Set answering” by pressing {v} or {e}, and press {>}.

4.Scroll to “Recording time” by pressing {v} or {e}, and press {>}.

5.Press {v} or {e} repeatedly to select the desired setting.

L You can also select the recording time by pressing a dialing button {1} (1 minute), {2} (2 minutes), {3} (3 minutes) or {0}

(“Greeting only”).

6.Press the right soft key ({SAVE}).

7.Press {OFF}.

Note:

LIf you select “Greeting only”, the unit will answer a call with the greeting message, and

then hang up. The unit will not record any incoming messages.

LYou can also program this feature with the base unit (feature #10 on page 69).

Setting remote operation code

Make sure the base unit and the handset are not being used.

1.Press {CONF/FUNCTION}.

2.Scroll to “Initial setting” by pressing {v} or {e}, and press {>}.

3.Scroll to “Set answering” by pressing {v} or {e}, and press {>}.

4.Scroll to “Remote code” by pressing {v} or {e}, and press {>}.

5.Enter a remote code using a 2-digit number (00–99).

L The default setting is “11”.

6.Press the right soft key ({SAVE}).

7.Press {OFF}.

Note:

LYou can also program this feature with the base unit (feature #11 on page 69).

Setting the mailbox 2 or 3 password

To prevent other users from retrieving your messages, program a password for mailbox 2 or 3.

Make sure the base unit and the handset are not being used.

1.Press {CONF/FUNCTION}.

2.Scroll to “Initial setting” by pressing {v} or {e}, and press {>}.

3.Scroll to “Set answering” by pressing {v} or {e}, and press {>}.

4.Scroll to “Set mailbox2&3” by pressing {v} or {e}, and press {>}.

5.Select the mailbox by pressing {e}

(“Mailbox2”) or {v} (“Mailbox3”).

L If the password has previously been assigned to the mailbox, it is displayed.

6.Enter a 2-digit number (00–99).

LIf you entered a wrong number, press

{HOLD/CLEAR} and enter the password again.

7.Press the right soft key ({SAVE}).

8.Press {OFF}.

To check the password

Repeat steps 1 to 5.

LThe password is displayed. When finished, press {OFF}.

To erase the password

Press {HOLD/CLEAR} in step 6, and press the right soft key ({SAVE}), then press {OFF}.

LYou will be able to access the mailbox without entering the password.

Note:

LYou can also program this feature with the base unit (feature #51 on page 71 and feature #52 on page 71).

Setting the room monitor feature

See page 48 for details. To turn ON the base unit room monitor feature using the handset, program as follows:

Use the handset. Make sure the base unit and the handset are not being used.

1.Press {CONF/FUNCTION}.

2.Scroll to “Initial setting” by pressing {v} or {e}, and press {>}.

3.Scroll to “Set base unit” by pressing {v} or {e}, and press {>}.

4.Scroll to “Room monitor” by pressing {v} or {e}, and press {>}.

5.Press {v} or {e} repeatedly to select the desired setting.

6.Press the right soft key ({SAVE}).

Note:

LYou can also set the base unit room monitor feature using the base unit (feature #74 on page 48).

76

Page 78
Image 78
Panasonic KX-FPG381 operating instructions Press the right soft key Save Press OFF, Setting the mailbox 2 or 3 password