Panasonic kx-tcd725em operating instructions Before Requesting Help

KX-TCD725EM-5(86~100) 01.10.24 14:40 Page 92

Before Requesting Help

Problem		Remedy
While programming or searching, the unit	•	To answer the call, press	. Start again from the
starts to ring and stops the program/search.		beginning after hanging up.
The unit does not display the caller’s	•	Other telephone equipment may be interfering with
phone numbers.		your telephone. Disconnect it. Try again.

• Other electrical appliances connected to the same outlet may be interfering with the Caller ID information. Telephone line noise may be affecting the Caller ID information.

The display goes to the standby mode while viewing the Caller List or phonebook.

•Do not pause for over 60 seconds while searching.

does not function.

•The handset is too far from the base unit.

•The handset is engaged in an outside call or is viewing the Caller List.

The paged handset does not answer.

•The handset is not in the same radio area.

•The handset is engaged in an outside call.

•The handset has been cancelled or has not been registered. Register the handset in the base unit (p. 80).

While using the intercom, two tones sound.		•	A call is being received. To answer, press		then
				.
The unit misdials when connected to a PBX.		•	Check the pause function (p. 36).
You cannot register the handset in the		•	The base unit has registered a maximum of
base unit.			6 handsets or the handset has registered a maximum
			of 4 base units.
		• There is interference from other electrical units.
			Locate the handset and base unit away from them.
		• You must finish registration within 1 minute after the
			confirmation tone sounds, or programming will be
			cancelled (p. 80).
When redialling with pressing	and	•	Press	.
, you cannot talk to the other party.

92