Panasonic kx-tcd725em Direct Call, To set the direct call number, To set the direct call mode

KX-TCD725EM-3(38~64) 01.10.24 14:38 Page 51

Direct Call

You can easily make a call using a stored direct call number by pressing or . Incoming calls are accepted. The factory preset is OFF.

After storing the direct call number, the unit will automatically switch to the direct call mode. When the direct call mode is on, you can ONLY dial the number stored in the direct call memory.

Make sure that the power is ON (p. 12), and the unit is in the standby mode.

To set the direct call number

1Press .

2Press or until the arrow points to

“Setting Handset”, then press .

3Press or until the arrow points to

“Call Option”, then press .

4Press or until the arrow points to

“Direct Call No.”, then press .

• “Enter Phone No ” is displayed.

5Enter the phone number up to 24 digits.

• If you misdial, press C . The digits are erased from the right. To erase all digits, press and hold C .

6Press .

7While “Save” is at the arrow, press .

8Press or to select “ON” or

“OFF”, then press .

•A beep sounds.

•The display will return to “Direct Call

No.”. To return to the standby mode, press

or wait for 60 seconds. “ ” will be shown at the top right corner on the

standby mode display when set to ON.

To set the direct call mode

ON/OFF

1Follow steps 1 to 3 on To set the direct call number.

2Press or until the arrow points

to “Direct ON/OFF”, then press .

3Press or to select “ON” or

“OFF”, then press .

•A beep sounds.

•The display will return to “Direct

ON/OFF”. To return to the standby mode,

press or wait for 60 seconds. “ ” will be shown at the top right corner on the

standby mode display when set to ON.

•When set to off , “ ” will go out.

Chapter 3 Programmable Function on the Handset

To dial the stored number

Make sure that “ ” is displayed, then press or .

•The number stored in the direct call memory is automatically dialled.

51