Chapter 4

Programmable Function on the Base Unit

63
Reset the Base Unit Settings
1Press .
2Press or until the arrow points
to “Setting Base”, then press .
Input Commandis displayed.
3Press , then enter the 4-digit base
unit PIN (p. 55).
0
4Press .
Abeep sounds.
The display will return to “Setting
Base”. To return to the standby mode,
press .
You can exit the programming mode any time
by pressing .
This function enables the base unit to clear the following settings at one time. They will return to their
initial settings.
Input Command
12------------
Ringer mode selection All handsets
Number of rings
(Selected then all handsets)
3
Earth/Time Break Recall Time Break Recall
Flash timing 80m seconds
Pause timing 3 seconds
Function Initial setting
Call restricted All clear
handset(s)
Call restriction All clear
number(s)
4-digit base unit PIN 0000
Base unit ringer volume 2 (MEDIUM)
Function Initial setting
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
KX-TCD725EM-3(38~64) 01.10.24 14:38 Page 63