Panasonic PT-D10000E manual Basic format, Control commands, Command Function of command Remarks

Using the serial terminals (continued)

Basic format

Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent in this order. Add parameters according to the details of control.

STX

A D

I 1 I 2

;

C1 C2

C3

:

P1 P2

Pn

ETX

	(2 bytes)		Two	ID
					Semicolon		Colon
			characters		(1 byte)
							(1 byte)
			(2 bytes)
Start						3 command		Parameter	End
(1 byte)		ZZ, 1 to 64 and 0A to 0Z				characters		(undefined length)	(1 byte)
						(3 bytes)
			ID designate

Attention

•No command can be sent or received for 10 to 60 seconds after the lamp starts lighting. Try sending any command after that period has elapsed.

•When transmitting multiple commands, be sure to wait until 0.5 of a second has elapsed after receiving the response from the projector before sending the next command. When sending commands without parameters, a colon (:) is not necessary.

Note

•When the wrong command is sent, the “ER401” or “ER402” status is sent from the projector to the personal computer.

•Projector ID supported on the RS-232C interface is ZZ (ALL) and a group of 1 to 64 and 0A to 0Z.

•The “STX” character code is 02 and the “ETX” character code is 03.

•If a command is sent with a projector ID specified, the projector will return answer back only in the following cases:

If it coincides with the projector ID,

ID specification is ALL and VPS-SYSTEM is the master, or ID specification is group and Group is the master.

Control commands

When controlling the projector from a computer, the following commands are available:

Command	Function of command			Remarks
PON	Power “ON”	In standby mode, commands other than “PON” are invalid.
		• While the lamp is ON and being controlled, a “PON” command will not be
	Power “OFF”
POF			accepted.
		Parameter
IIS	Switch input modes	VID = VIDEO		SVD = S-VIDEO	DVI = DVI-D
		RG1 = RGB1		RG2 = RGB2	AUX = AUX
		Parameter
QSL	Query for active lamp mode	0	= QUAD, 1 = L1/L4, 2 = L2/L3, 3 = DUAL, 4 = L1/L2/L3, 5 = L1/L2/L4,
		6	= L1/L3/L4, 7 = L2/L3/L4, 8 = TRIPLE, 9 = L1, 10 = L2, 11 = L3, 12 = L4,
		13 = SINGLE
		Parameter
LPM	Active lamp mode	0	= QUAD, 1 = L1/L4, 2 = L2/L3, 3 = DUAL, 4 = L1/L2/L3, 5 = L1/L2/L4,
		6	= L1/L3/L4, 7 = L2/L3/L4, 8 = TRIPLE, 9 = L1, 10 = L2, 11 = L3, 12 = L4,
		13 = SINGLE

Note

• If you need a detailed command list, please contact your dealer.

104 – ENGLISH