Panasonic PT-D10000E Powering off the projector, # Press Power Standby, Press the marked side

Projection (continued)

#

% # $

$

&

Powering off the projector

#Press POWER STANDBY “”.

• A confirmation screen will appear.

POWER OFF

OK CANCEL

CHANGE

ENTER EXECUTE

$ Press ◄ or ► to select “OK” and press ENTER.

(or press POWER STANDBY “” again.)

•The projection of the image stops, and the power indicator lamp of the main unit lights up orange. (The cooling fan keeps running.)

%Wait until the power indicator lamp of the main unit turns to red (i.e., until the cooling fan stops). (Approx. 3 minutes)

•While the cooling fan is still running, never turn off the MAIN POWER switch, nor unplug the projector from the outlet.

&Press the “○” marked side of the

MAIN POWER switch to remove all power from the projector.

Note

•Turning on the power supply will not light up the light source lamp if the lamp is in the process of cooling down after turning off the power supply. To light up the lamp, turn on the power supply again when the lamp has been cooled sufficiently.

•The projector consumes approximately 25 W of power even in standby mode. (Power indicator lamp lit in red)

•If you re-power the projector after shutting off the main power inadvertently, the projection lamp may remain unlit. Please turn the power on again after a while.

Be sure to set the date and time when the projector is turned on for the first time after being purchased. For details, refer to “Setting the date and time” on page 81.

36 – ENGLISH