Panasonic PT-D10000E, PT-DW10000E manual Adjusting the colour, Matching using a colorimeter

	Option1 settings (continued)
	■ If “3COLORS” or “7COLORS”
					Adjusting the colour
		was selected in step 2.			matching using a colorimeter
	3. Press ENTER.
					The “R (Red)”, “G (Green)”, “B (Blue)”, “Cy (Cyan)”,
		• The “COLOR MATCHING: 3COLORS” or
			“COLOR MATCHING: 7COLORS” screen will		“Mg (Magenta)”, “Ye (Yellow)” and “Wh (White)”
			be displayed.		colours can be changed to the desired hues using
					a colorimeter which is capable of measuring the
					chromaticity coordinates and luminance.
			COLOR MATCHING:3COLORS
			R		■ Inputting the current luminance
			B
			G
					and chromaticity coordinates
			AUTO TESTPATTERN	ON
			MENU SELECT		1. Press ▲▼ to select “COLOR
			ENTER SUB MENU
					MATCHING”.
	4. Press ▲▼ to select “R”, “G” and
		“B”.
						OPTION1
						COLOR MATCHING
								OFF
						LARGE SCREEN CORRECTION		OFF
			3COLORS:R
						AUTO SIGNAL		OFF
			R	2048
						AUTO SETUP
			G	0
						BACK COLOR		BLUE
			B	0
						DVI EDID		EDID2(PC)
			MENU SELECT
						AUX DVI EDID		EDID2(PC)
			ADJUST
						P IN P		OFF
						FUNC1		P IN P
	5. Press ENTER.					OSD POSITION		2
						OSD MEMORY		ON
	6. Press ◄► to adjust the values.						MENU SELECT
		• These values can be adjusted from 0 to 2048.					CHANGE
					2. Press ◄► to select “MEASURE”.
	Note
	• The effects of correcting the adjustment colour:				3. Press ENTER.
	When tuning the correction colour that is the same
					• The “MEASURE MODE” screen will be
	as the adjustment colour: the brightness of the
						displayed.
	adjustment colour changes.
	When tuning the correction colour RED: RED is
						MEASURE MODE
	added to or reduced from the adjustment colour.					MODE
								709MODE
	When tuning the correction colour GREEN: GREEN					MEASURED DATA
	is added to or reduced from the adjustment colour.					TARGET DATA
	When tuning the correction colour BLUE: BLUE is					AUTO TESTPATTERN		ON
							MENU SELECT
	added to or reduced from the adjustment colour.
						ENTER	SUB MENU
	• This adjustment should be carried out by a person
					4. Press ▲▼ to select “MEASURED
	who is familiar with the projector or by a service
	person because a high level of skill is required to				DATA”.
	make successful adjustment.
					5. Press ENTER.
	• Pressing DEFAULT will restore the factory defaults
	for all items.				• The “MEASURED DATA” screen will be displayed.
	• When any setting other than “OFF” has been
						MEASURED DATA		1/2
	selected for colour matching, the “COLOR TEMP.”
						Bk	Y		2
	setting is fixed at “USER1”.						x		0.350
							y		0.360
						R	Y		300
							x		0.670
							y		0.330
						G	Y		2500
							x		0.350
							y		.0630
						B	Y		200
							x		0.150
							y		0.050
							MENU SELECT
							ADJUST
68 – ENGLISH