Panasonic PT-DW10000E Symptoms Check point, Power does not turn on, No image appears on screen

Before asking for service … try to check the following points again.

Symptoms		Check point	Page
	•	Is the power cord securely plugged in the receptacle?	34
	•	Is the MAIN POWER switch put to the “O” position?	35, 36
	•	Is power supply live at the receptacle?	34
	•	Is the temperature monitor (TEMP) lamp on the projector front	107
		lighting or blinking?
Power does not turn on
	•	Is the lamp monitor (LAMP) lamp on the projector front lighting or	107
		blinking?
	•	Is the lamp unit cover completely attached?	111
	•	Was operation of ID setting made in a correctly way?	18, 75
	•	Are all four lamp units installed?	109, 110
	•	Is the lens covered with the cap?	25
No image appears on screen	•	Is the screen image input connected in a correct manner?	43, 54
	•	Is the device(s) connected to the projector working normally?	-
	•	Is the shutter function used?	43
	•	Is the lens in focus?	37
Screen image is blurred	•	Is the projection distance adequate?	21, 22
	•	Is the lens dirty?	-
	•	Is the projector placed vertical to the screen?	20
Pale colour / bad colour tint	•	Are colour strength and colour tint correctly adjusted?	50, 51
	•	Is the device(s) connected to the projector adjusted correctly?	-
	•	Are dry batteries consumed?	-
	•	Is polarity correct in battery setting?	17
	•	Are there any obstacle between the remote control and the beam	17
		receiving window?
	•	Are you trying to operate the remote control beyond the effective	17
Remote control does not		range?
function	•	Is the remote 2 (REMOTE2) terminal used for external control?	106
	•	Is any external light interfering with the remote control operation?	-
	•	Was operation of ID setting made in a correctly way?	18, 75
	• Is the LOCK button of the remote control at the lock position?		11
	•	Is adjustment value protection enabled? Press ▼+ ▼ +	64
		ENTER+ ▼ + ▼ + ENTER to cancel the protection.
	•	Is the input selector set to correct position?	43, 54
Abnormal image on the	•	Is the correct signaling system selected?	54
screen	•	Are there any malfunctions on the source side, such as bad video	-
		tape?
	•	Are you supplying a signal that is not compatible with the projector?	119
	•	Is the cable too long?	-
Images from PC are not	•	Is the correct signal destination set for notebook computer screen	-
		image?
projected
	•	Use Fn and F3 keys for setting. (For details, refer to the instruction	-
		manual of the computer.)

Information

ENGLISH – 113