Panasonic PT-D10000E manual Adjusting the clamp position, Edge blending adjustment, Blending

How to use ADVANCED MENU (continued)

Note

•The abovementioned vertical stripes will not appear on the screen when all signals are input.

•The picture may be distorted during the adjusting operation, but this is not a fault.

•The input resolution can be adjusted only when RGB signal input is applied with RGB1 and RGB2 IN.

Adjusting the clamp position

Use the clamp position adjustment to achieve the optimal value when dark areas of the image are crushed or displayed in green.

1. Press ▲▼ to select “CLAMP POSITION”.

ADVANCED MENU

DIGITAL CINEMA REALITY	AUTO
BLANKING
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING	OFF
FRAME DELAY	DEFAULT
RASTER POSITION

MENU SELECT

ENTER SUB MENU

2.Press ENTER.

•The “CLAMP POSITION” screen will be displayed.

CLAMP POSITION

POSITION1

MENU SELECT

ADJUST

Edge blending adjustment

This projector has the function to hide the seams for multi-screens.

1.Press ▲▼ to select “EDGE

BLENDING”.

ADVANCED MENU

DIGITAL CINEMA REALITY	AUTO
BLANKING
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING	OFF
FRAME DELAY	DEFAULT
RASTER POSITION

MENU SELECT

CHANGE

2. Press ◄► to switch “EDGE
BLENDING”.
• The setting will change as follows each time
	◄► is pressed.
	OFF	ON	USER
•	OFF:
	When the multi-screens are not going to be
	used.
•	ON:
	When the tilting inside the unit is to be used for
	the tilting of the edge blending area.
•	USER:
	When a specific tilting is to be used for the
	tilting of the edge blending area. (Separate
	software is required to establish these settings.
	Consult your dealer.)

3.Press ◄► to adjust.

•The value changes from 1 to 255.

•The optimal value for the clamp position adjustment

If dark areas are crushed:

The optimal value is the point where the dark area is best improved.

If the dark areas are displayed in green:

The optimal value is the point where the green area becomes dark and clear.

Note

•The clamp position can be adjusted only when the RGB signal input is applied with RGB1 and RGB2 IN.

3.Press ENTER.

•The “EDGE BLENDING” screen will be displayed.

EDGE BLENDING

UPPER	START	0
OFF	WIDTH	128
LOWER	START	0
OFF	WIDTH	128
LEFT	START	0
OFF	WIDTH	128
RIGHT	START	0
OFF	WIDTH	128
MARKER		OFF

BRIGHT ADJUST
MENU SELECT
ADJUST	ENTER CHANGE

62 – ENGLISH