Panasonic PT-D10000E manual Adjusting the zoom ratio, Clock phase adjustment, Interlocked, Phase

Adjusting the position (continued)

	6. Press ◄► to switch
Adjusting the zoom ratio
	“INTERLOCKED”.
This adjusts the size of the projected pictures.
	• The setting will change as follows each time
1. Press ▲▼ to select “ZOOM”.	◄► is pressed.

POSITION

SHIFT

ASPECT	DEFAULT
ZOOM
CLOCK PHASE	0
KEYSTONE

MENU SELECT

ENTER SUB MENU

2.Press ENTER.

• The “ZOOM” screen will be displayed.

OFF ON

•OFF :

The “V” and “H” settings are used as the vertical and horizontal zoom ratios respectively.

•ON :

The zoom ratio is set to the “HV” setting. This allows the pictures to be zoomed at equal vertical and horizontal ratios.

Note

•When “ASPECT” is set to “THROUGH”, “ZOOM” will not appear.

ZOOM

MODEINTERNAL

INTERLOCKEDOFF

V100%

H100%

HV100%

MENU SELECT

CHANGE

Clock phase adjustment

Clock phase adjustment achieves the best image when the screen flickers or halo is observed around the contour.

1.Press ▲▼ to select “CLOCK

PHASE”.

3.	Press ▲▼ to select “MODE”.
		POSITION
4.	Press ◄► to switch “MODE”.	SHIFT
		ASPECT	DEFAULT
	• The setting will change as follows each time
		ZOOM
	◄► is pressed.	CLOCK PHASE	0
		KEYSTONE

INTERNAL FULL

•INTERNAL:

Enlarges the size of the pictures to within the

default aspect ratio.		MENU SELECT
		ADJUST
• FULL:
Enlarges the pictures using the whole of the	2. Press ◄► to adjust the level.
display area.

• The value changes from 0 to 31. Adjust so that

5. Press ▲▼ to selectthe amount of interference is at a minimum.

“INTERLOCKED”.

		Note
ZOOM
MODE		• No optimal value may be obtained if the output
	INTERNAL
INTERLOCKED	OFF	of the PC to which the signal input is applied is
V	100%	unstable.
H	100%
		• No optimal value may be obtained if the total
HV	100%
MENU SELECT		number of dots is not correct.
CHANGE		• The clock phase can be adjusted only when RGB
		signal input is applied with RGB1 and RGB2 IN.

58 – ENGLISH