Panasonic UF-6200 operating instructions Adjusting the Paper Cassette for the Paper Length

Adjusting the Paper Cassette for the Paper Length

How to Adjust the Paper Cassette for the Paper Length

The factory default Paper Length setting for the Paper Cassette is Letter size. To change the paper length to Letter or Legal size, follow the steps below.

1

Release Latch

Paper Length Guide

Paper Width Guide

Max. Paper

Capacity Mark

LTR

A4

LGL

1.Remove the paper from the Paper Cassette and place the cassette upside down on a flat surface.

2.While pushing down on the release latch, pull out the Paper Length Guide.

3.Turn the Paper Cassette upright.

4.Insert the Paper Length Guide hooks into the appropriate paper length slots (Letter or Legal) and slide the guide towards the back of the cassette until it locks in place.

5.Load the paper into the Paper Cassette.

Slide the paper width guide to the left until it lightly touches the stack of paper without bending the paper. The paper must fit squarely and firmly between the Paper Width Guide and the right side of tray. If it does not, the paper may feed into the printer incorrectly resulting in a paper jam.

Caution:Make sure that the paper is set under the metal Paper Separation Clips and that it does not exceed the Maximum Paper Capacity Mark. You can load about 250 sheets (20 lb weight). For paper specifications. (See page 153)

6.Replace the Paper Cassette Cover to the appropriate paper position (LTR, A4 or LGL).

2 Set it with the Control Panel of the machine.

7.Slide the Paper Cassette into the machine.

The Recording Paper Size setting of the Fax Parameter No. 23 must match the paper loaded in the cassette. If you change the Recording Paper Size, please change the setting accordingly in the Parameter No.23 (REC. PAPER SIZE). (See page 37)

NOTE

1.If you forget to change the Recording Paper Size setting in Fax Parameter No. 23 when different paper is installed in the cassette, the unit will Stop printing after the 1st page of an Incoming Fax and display a "PAPER SIZE MISMATCH" error. Then, the Recording Paper Size setting automatically adjusts to the proper size and the unit resumes printing the Incoming Fax from the 1st page.

22